Wednesday, March 30, 2011

Rehousing a Rocktek Flanger

Not really a huge fan of plastic enclosures, I decided to rehouse a worthy Rocktek Flanger in the enclosure of an MXR Stereo Chorus (with a dead Reticon chip).

I removed the Flanger from the enclosure. Q6 was removed and jumpered to put the flanger in an "always on" mode. D3 was also removed. True bypass switching will be used on this project.



After verifying the "always on" mod I then removed the in/out jacks and all the pots. I purchased new replacement pots and put those in the MXR enclosure. I used the old jacks from the MXR chorus. I needed to drill holes for the on/off LED, the LFO rate indicator LED and the Feedback pot.



Usually a stereo input jack is used to switch a connection to the power supply (ie, turn on the box). None of the MXR jacks were stereo. I installed a SPST on/off switch in the hole for the old AC power connection. The wires for the on/off switch were connected to the input jack ground connections on the flanger PCB.

The flanger also needed some ground jumpers on the old pot connections.



Another beautious mod was to decrease the value of the feedback resistor. The pedal can now go into howling self oscillations when the feedback knob is cranked! My dog loves these sounds so much that he howls back at the pedal.



More info:
Pedal Area
Wikipedia entry for flanging

3 comments:

Kaospilot said...

nice ! I'd like to rehouse mine too, could you draw some diagram for 3pdt switch? well if you dont mind :)

merseymale said...

Detailed Instructions Please! 😉👍

Carlos Pilan said...

Hi, Jorge.

I am replacing the "level" pot on my Rocteck Flanger, but at the tech company I am ordering from, they want to know about the impedance, in Ohms, that pot needs. Do you know? Thanks